Open sub-grid slot wall insulation materials, Mounted drip, leak-proof practice outside the window 1, the insulation layer design requirements should be set up sub-lattice seam, and in accordance with the requirements of bomb control line, when no design requirements should press spaced not more than 15m set Ge dividing joint, slit width of 15mm sew strips embedded in an elastic closed-cell foam fill material, seal the surface with a sealant to fill job 6.2.6 finish layer coating process to clean check grassroots - Flexible repair putty - Matte Paper - the first pass Scraping flexible putty - matte paper - coated dichroic line - primer paint brush - up putty sanding paper - brush coat paint - sanding paper - brush topcoat paint - facing layer insulation slurry acceptance wipe YT: 1, thermal insulation mortar site preparation: ① according to water: heat powder = 1: 1.5 weight ratio of insulation slurry formulation (available water absorption and different construction according to different wall materials Seasonal adjust the ratio of water to facilitate handling) ② first water (water should comply with concrete standard) into the blender, mixer start, then slowly pour YT insulation materials; mixing time of 3-5 minutes, caused by the slurry a uniform paste body, can be used. ③ insulation slurry preparation, it should be used within a half hour. Construction 2.YT insulation slurry should be top-down, hierarchical be inorganic wall insulation material processing, batch control the thickness of the underlying plaster about 10mm, and uniformly dense coverage of the primary wall; should be put on the bottom of the next batch of slurry again After the basic material hardens and (close to 60% of water, after half drying) were. 3 When designing the thermal insulation thickness is greater than 30mm inorganic wall insulation materials manufacturers, every time batch wipe thickness should be controlled within 15mm. 4, insulation slurry and finally a (surface layer) of plastering should reach red bars Nanyang wall thickness insulation material, the surface with a slightly dilute slurry granted full and scraping feet scraping with a large solid wooden trowel smooth, dense smooth surface requirements . 5, finishing layer of paint type, insulation slurry after the initial setting of the elastic brushing primer. 6, the construction should finish layer of the insulation layer is cured and dried (depending on the ambient temperature appropriate for the 7-15d) performed. Nanyang wall insulation wall insulation materials _ _ Sheng Hui Nanyang Technology offered by Nanyang Technology Co., Ltd. Sheng Hui. Sheng Hui Nanyang Technology Co., Ltd. (www.nyshenghui.com) strong, credible, Nanyang in Henan thermal insulation material industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Sheng Hui Nanyang Technology into the brilliant and you work for a better future!